Installing the battery
- Install the battery (4).
- Position the battery carrier with the screw (2) as shown.
- Tighten the battery carrier with the screw (2).
TIGHTENING TORQUE SPECIFICATIONS
| Battery carrier to body | ||
| M8 screw | Tightening torque | 10 Nm |
- Position the positive battery terminal on the positive battery terminal.
- Tighten the nut on the positive battery terminal.
TIGHTENING TORQUE SPECIFICATIONS
| Positive battery terminal to battery | ||
| Nut | tightening torque | 5 Nm |
- Close positive terminal cover (1).
- Position the vent hose (3).
- Clip the luggage compartment antenna with the holder (1) to the cargo area floor (2).
- Position the battery roll-over bar (3).
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATIONS
| Battery rollover protection bracket to luggage compartment floor | ||
| screw | Tightening torque | 8 Nm |
- Tighten nut (1).
TIGHTENING TORQUE SPECIFICATIONS
| Battery rollover protection bracket to luggage compartment floor | ||
| Nut M6 | Tightening torque | 8 Nm |
Follow-up work
- Refer to CHECKING THE VENTING HOLES OF THE BATTERY .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to REGISTER BATTERY CHANGE .