Installing the 12 V dual storage system

• Install the 12 V dual storage system (3).
• Position the positive battery cable (2) on the positive battery terminal.
• Tighten nut (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Check 

• Check the guide (1) and the snap-in lugs (2) on the positive terminal cover (3) for damage.

Courtesy of BMW OF NORTH AMERICA, INC.

Result 

» The guide (1) or snap-in lugs (2) are damaged.

Measure

• Replace the positive terminal cover (3).

• Connect connectors (5) and lock.
• Install the battery rollover protection bracket (4).
• Tighten nut (3).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Retainer 12-V dual storage system
  Nut M8	Tightening torque	15 Nm

• Position the positive terminal cover (2).
• Clip in the detents (1) of the positive terminal cover (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING TENSION STRUT ON SHOCK TOWER .
• Refer to INSTALLING WINDSHIELD PANEL COVER .
• Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
• Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
• Refer to CONNECTING ALL BATTERY GROUND LEADS .
• Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .
• Refer to REGISTER BATTERY CHANGE .