Removing power distribution for front positive battery cable
WARNING:
High-voltage system.
The high-voltage system operates on the basis of hazardous, electrical voltage and high currents. Mortal hazard through electric shock!
The high-voltage system operates on the basis of hazardous, electrical voltage and high currents. Mortal hazard through electric shock!
- All work on the high-voltage system may only be carried out by specially trained and technically experienced personnel.
- For additional information see:
- For additional information see:
Preliminary work
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
- Refer to REMOVING THE COVER OF THE REAR RIGHT ENGINE COMPARTMENT .
- Refer to REMOVING LEFT AND RIGHT WIPER ARM .
- Refer to REMOVING THE COWL COVER .
- Refer to REMOVING TRAILING LINK AT SPRING BOLT .
- Loosen screws (1) .
- Loosen the detent (2) .
- Feed sealing frame of power distribution (3)
out upwards.
- Release cover (1) at detents (2) .
- Remove the cover (1)
in an upwards direction.
- Undo the nut (1) and feed out the corresponding cable.
- Undo the nuts (2) and feed out the corresponding cables.
- Release the cable clip (arrow).
- Loosen screws (1) .
- Loosen screw (2) .
- Feed out the power distribution box (3)
in an upwards direction.
- Unlock and disconnect connector (1)
.
- Lever out the locks (1) at the connectors (2) .
- Detach connectors (2) .