Install the front power distribution box
- Connect connector (1) and close the lock (2) .
- Connect connector (3)
and close the lock (4)
.
- Connect connectors (1)
and lock.
- Feed in the power distribution box (3) in a downwards direction.
- Tighten down screw (2) .
TIGHTENING TORQUE SPECIFICATIONS
| Front power distribution box | ||
| Screw TS4x16 | Tightening torque | 2.6 Nm |
- Tighten the screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Front power distribution box | ||
| M8x35 screw | Tightening torque | 28 Nm |
TIGHTENING TORQUE SPECIFICATIONS
| Auxiliary terminal for jump starting | ||
| Flange nut M8 | Tightening torque | 19 Nm |
- Feed in the accompanying cable and tighten the nut (2) .
TIGHTENING TORQUE SPECIFICATIONS
| Positive battery cable | ||
| Positive pole screw | tightening torque | 15 Nm |
- Feed in the cover (1) in a downwards direction.
- Check the detents (2) are seated correctly.
- Feed in the power distribution box sealing frame (3) in a downwards direction.
- Tighten the screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Front power distribution box sealing frame | ||
| Bolt RF5x25 | tightening torque | 2.5 Nm |
- Check that the detent (2) is fitted correctly.
Follow-up work
- Refer to INSTALLING TENSION STRUT ON SHOCK TOWER .
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .