Installing the underbody protection of the steering gear or the front thrust field
NOTE:
TECHNICAL INFORMATION
Different variants may be installed depending on the vehicle equipment.
Different variants may be installed depending on the vehicle equipment.
- Version A:
Insert steering gear aggregate protective plate (1).
Tighten screws (arrows).
TIGHTENING TORQUE SPECIFICATIONS
| Underbody protection | ||
| screw | Tightening torque | 3 Nm |
- Version B:
Replace screws (2).
Parts: Screws
Position the front stiffening plate (1).
Tighten down screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Thrust field to front axle support | ||
| M8 Replace screws. |
Joining torque | 25 Nm |
| Angle of rotation | 70° | |
- Tighten down screws (3).
TIGHTENING TORQUE SPECIFICATIONS
| Cover, steering unit | ||
| screw | Tightening torque | 3 Nm |