Install the positive battery cable from the alternator to the auxiliary terminal for jump starting
Positive battery cable of alternator
Precondition
CAUTION:
Improper routing of the positive battery cable.
Risk of short circuits!
Risk of short circuits!
- Route the positive battery cable without abrasions and do not trap.
- Insert and install the positive battery cable (1).
- Insert and install the positive battery cable (2).
- Secure clamps (1).
- Make sure the locking mechanism (arrow) engages correctly.
- Insert and install the positive battery cable (2).
- Tighten nut (1).
TIGHTENING TORQUE SPECIFICATIONS
| Positive battery cable to the alternator | ||
|---|---|---|
| M8 | Tightening torque | 19 Nm |
- Fasten the positive battery cable (1) with the holders (arrows).
- Secure the positive battery cable (1) with the clamp (arrow).
- Insert and install the positive battery cable (3).
- Secure clamps (2).
- Tighten nut (1).
TIGHTENING TORQUE SPECIFICATIONS
| Battery positive lead to battery positive terminal | ||
|---|---|---|
| M8 | Tightening torque | 19 Nm |
- Insert and install the cover (2) in the direction of the arrow.
The locks (1) must engage audibly.
Follow-up work
- Refer to INSTALL CONTROL UNIT BRACKET .
- Refer to INSTALL THE INTEGRATED POWER SUPPLY MODULE (PDM) .
- Refer to INSTALLING THE DME CONTROL UNIT .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE CENTER COWL UPPER PART .
- Refer to INSTALLING TENSION STRUT ON SHOCK TOWER .
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALL LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALL THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to IF THE DME CONTROL UNIT IS REPLACED: PROGRAM/CODE DME CONTROL UNIT .