Installing the wiring harness section for the Valvetronic servomotor of cylinders 5 to 8
- Insert and install the wiring harness section (1) for the Valvetronic servomotor.
- Connect the connector to the Valvetronic servomotor and lock it audibly.
- Route the coolant hose (2) .
- Connect and audibly lock coolant hose (2) .
- Tighten down screw (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Connecting branch for coolant pump (aluminum pipe) to cylinder head | ||
| M6x18 | Tightening torque | 10 Nm |
- Secure all cables (1)
on the holder for the DME control unit.
- Connect all connectors (1)
to the DME control unit starting in the back and audibly lock them in place.
- Install and lock cover (2) .
Follow-up work
- Refer to INSTALLING COVER FOR THE LEFT DME CONTROL UNIT .
- Refer to CONNECTING THE COOLANT HOSE TO THE RADIATOR .
- Refer to INSTALLING THE LEFT THROTTLE BODY .
- Refer to INSTALLING THE LEFT-HAND CHARGE AIR COOLER .
- Refer to INSTALLING THE LEFT UNFILTERED-AIR DUCT .
- Refer to CONNECTING THE LEFT CHARGE AIR LINE TO THE TURBOCHARGER .
- Refer to INSTALLING INTAKE FILTER HOUSING .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to CONNECTING THE COOLANT HOSE TO THE AUXILIARY COOLANT PUMP .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
- Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING FRONT CROSS CONNECTION (FRONT-END STRUT REMOVED) .
- Refer to INSTALLING BOTH FRONT-END STRUTS .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT CENTER .
- Refer to FILLING THE COOLING SYSTEM WITH THE VACUUM FILLING UNIT .
- Refer to FILLING THE LOW-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
- Refer to VENTING THE HIGH-TEMPERATURE COOLANT SYSTEM .
- Refer to VENTING THE LOW-TEMPERATURE COOLING SYSTEM .