Install the trim on the side panel
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Build level through 03.19:
Replace the trim (1).
Parts: Trim
The trim (1) at the side panel cannot be removed without damaging it and must always be replaced.
Guide the trim (1) at the side panel forward and snap it in the clamps (2).
- Build date after 03.19:
Check the clips (2) and the clamps (3).
Replace any defective or missing clips (2) and the clamps (3).
Guide in the trim at the side panel (1) and engage it at the clamps (3) and clips (2).