Install the left-hand and right-hand crash lever

• Replace clip nut (1)  .

  Parts:  Clip nut

  Courtesy of BMW OF NORTH AMERICA, INC.

• When positioning the crash lever (1)  watch out for the Christmas tree clip.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the tension strut (4)  on the front subframe.
• Position the crash lever (3)  on the front axle support.
• Replace the screw (1)  .

  Parts:  Screw

• Feed the screw (1)  into the spring Circlip (2)  .
  NOTE: Do not yet tighten the screw (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting the normal position 

• Position special tool 2 358 630  .
• Hand-tighten the wheel bolts (1)  .
• Insert the universal jack into the special tool 2 358 630  .

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: RISK OF DAMAGE 
  Failure to comply with the specification. 
  Component damage. 

  • All specifications must  be observed and complied with.
• For installed output shaft: 

  It is imperative  to protect the output shaft (1)  from damage with a cloth (2)  .

  The spring strut (3) must  be pressed in arrow direction slightly to the side before lifting the swivel bearing (A).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Use the universal jack and the special tool 2 358 630 to lift the swivel bearing until it reaches the  dimension (A)  .

  Dimension (A)  = 402 mm

  Ensure a sufficient distance between the output shaft and the spring strut.

  NOTE: Dimension (A) must not be undershot.

Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the screw (1)  in NORMAL POSITION .
  NOTE: Drive the steering (swivel bearing) a little inwards.

Remove the special tool 

Courtesy of BMW OF NORTH AMERICA, INC.

• Lower the workshop jack and set it aside.
• Loosen lug bolts (1)  .
• Remove the special tool 2 358 630  .

Courtesy of BMW OF NORTH AMERICA, INC.