Installing the drive belt for the coolant pump

• Feed in and position the drive belt (1)  .

  If necessary, observe the marked direction of rotation.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Make sure the drive belt (1)  for the coolant pump is correctly positioned at the coolant pump (3)  in the marked area. 
• Make sure the drive belt (1)  for the coolant pump is correctly positioned at the vibration damper (2)  in the marked area.
• Make sure the drive belt (1)  for the coolant pump is correctly positioned at the tensioning pulley (4)  in the marked area. 

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten tensioning pulley in the direction of the arrow up to the stop.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace the nut (1)  .

  Parts:  Nut

• Tighten nut (1)  .
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Nut on belt tensioner
  M10 Replace nut.	Tightening torque	38 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

  Check 

• Check if the Torx socket (2)  is located in the marked area (arrow).

  Result 

  » The Torx socket (2)  is outside the marked area.

  Measure

  • Tension the drive belt again.
• Install the cover (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE ACOUSTIC COVER FOR THE ENGINE AT THE FRONT .
• Refer to INSTALLING CHARGE AIR LINE .
• Refer to INSTALLING CLEAN AIR PIPE .
• Refer to INSTALLING RESONATOR .
• Refer to INSTALLING ACOUSTIC COVER .