Removing the LED module on the right-hand decorative strip

NOTE: The description is provided only at one component. The procedure is the same for all other components.

• Disconnect the connector (1)  from the LED module (2)  .
• Loosen the detent on the LED module (2)  .
• Release the fiber-optic conductor from the first detent (arrow).
• Pull LED module (2)  out of holder.

  Courtesy of BMW OF NORTH AMERICA, INC.

• If applicable, release the detent with the help of a screwdriver (blade: 3 mm).
• Unclip the LED module (1)  from the fiber-optic conductor (2)  .

Courtesy of BMW OF NORTH AMERICA, INC.