Remove the rear top cross connection
Preliminary work
- Refer to REMOVING THE COVER FOR THE CENTER ENGINE COMPARTMENT .
- Refer to REMOVING FRONT ORNAMENTAL GRILLE .
- Refer to PARTIALLY REMOVING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER .
- Refer to REMOVING FRONT BUMPER COVER .
- Refer to REMOVING BOTH HEADLIGHTS .
- Refer to REMOVING THE CENTER TOP CROSS CONNECTION .
- Refer to REMOVING THE WHEEL ARCH COVER ON THE FRONT LEFT AND BOTTOM RIGHT .
- Refer to REMOVING THE FANFARE HORN ON THE LEFT .
- Refer to REMOVING THE FANFARE HORN TOWARDS THE RIGHT .
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING LEFT INTAKE SILENCER HOUSING .
- Refer to REMOVING RIGHT INTAKE SILENCER HOUSING .
- Refer to REMOVING THE LEFT-HAND AIR DUCT .
- Refer to REMOVING RIGHT AIR DUCT .
- Refer to REMOVING LEFT INTAKE PORT .
- Loosen screws (1)
.
- Loosen screws (1)
and (2)
.
The screw (2) (M10x40) is installed on the right-hand side only.
- Pull the support (3) slightly toward the front and remove the cross connection (4) .