Shifting vehicle into normal position (all 7' series models 2016-2022)

In vehicles with air suspension systems: Perform ride height adjustment with diagnostic system.
Check vehicle interior and trunk (including luggage compartment well) for load status, if applicable, unload vehicle.

Lay prescribed DIN load into the vehicle.

TECHNICAL DATA SPECIFICATION

DIN normal position loading
Vehicle has a full tank. Vehicle is completely assembled.
Per front seat (seat in center position)	68 kg
On the center rear seat	68 kg
Centered in the trunk	21 kg

In vehicles with air suspension systems: After the vehicle has been loaded, start the engine and wait until the vehicle ride height has been adjusted.
NOTE: (The doors must be closed)