Install the active stabilizer in front

• Position active anti-roll bar (3)  on front axle support.
• Replace screws (1)  and (2)  .

  Parts:  Screws

• Tighten down screws (1)  and (2)  .

  The screws have different lengths. Pay attention to installation position!

  Screws (1)  = M12x89

  Screws (2)  = M12x50

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Anti-roll bar to front axle support
  M12 Replace screws.	Joining torque	100 Nm
  	Angle of rotation	45°

• Position wiring harness on holder.
• Tighten the bolt (1)  with the ground strap on the holder and wiring harness.
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Front active stabilizer cable with ground strap to holder
  	tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the holder of the connector for the active stabilizer on the front axle support.
• Tighten down screw (1)  .
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Active stabilizer connector bracket to front axle support
  	tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect plug connections (1)  and (2)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY ON THE RIGHT .
• Refer to INSTALLING FRONT STIFFENING PLATE .
• Refer to INSTALLING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
• Refer to INSTALLING THE FRONT RIGHT WHEEL .
• Refer to FOR REPLACEMENT: PROGRAMMING/CODING THE ACTIVE STABILIZER .