Installing both tie rod ends

Installing tie rod end 

• Screw tie rod end onto the tie rod up to dimension (A), which was determined before removal.
  NOTE: If necessary, hold the tie rod with an opened wrench for counter support.
• Tighten down screw (1)  .
  TIGHTENING TORQUES SPECIFICATION
  
  

  Tie rod end to tie rod
  M10	tightening torque	32 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the tie rod end (2)  on the swivel bearing.
• Replace nut (1)  .

  Parts:  Nut

• Tighten nut (1)  .
  NOTE: If necessary, counter-hold at the Torx socket.

Courtesy of BMW OF NORTH AMERICA, INC.