Install the wiring harness of the integrated power supply module (PDM)
Wiring harness of the integrated power supply module (PDM)
NOTE:
RISK OF DAMAGE
Malfunction or failure of the DME.
Grounding points that are not screwed on may lead to malfunction or failure of the DME.
Malfunction or failure of the DME.
Grounding points that are not screwed on may lead to malfunction or failure of the DME.
- Screw all screw points of the cable ducts on again. Some of the screw points are also grounding points.
- Route the wiring harness of the integrated power supply module (PDM) and fasten it with the clamps.
- Fasten the ground cable with the bolt (3) at the grounding point.
- Tighten down screw (3) .
TIGHTENING TORQUE SPECIFICATIONS
| Ground cable to cylinder head cover/cylinder head | ||
| M6 | tightening torque | 10 Nm |
- Connect the connector (1) to the integrated power supply module (PDM) and lock it.
- Connect the connector (2)
to the DME control unit and lock it.
The connectors must engage audibly.
- Route the wiring harness of the integrated power supply module (PDM) and fasten it with the clamps.
- Connect the connector (1) to the DME control unit and lock it.
- Connect the connector (2)
to the wiring harness section for the sensor system of cylinders 7 to 12.
The connectors must engage audibly.
- Fasten the ground cable with the bolt (3) at the grounding point.
- Tighten down screw (3) .
TIGHTENING TORQUE SPECIFICATIONS
| Ground cable to cylinder head cover/cylinder head | ||
| M6 | tightening torque | 10 Nm |
Follow-up work
- Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
- Refer to INSTALLING COVER FOR THE LEFT DME CONTROL UNIT .
- Refer to INSTALLING COVER FOR THE RIGHT DME CONTROL UNIT .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .