Remove bearing bracket
Preliminary work
- Refer to REMOVING FRONT LEFT OR RIGHT WHEEL .
- Refer to IF INSTALLED: REMOVING THE HUB CAP .
- Refer to LOOSENING THE OUTPUT SHAFT FROM THE WHEEL BEARING .
- Refer to REMOVING THE COVER IN THE ENGINE COMPARTMENT ON THE REAR LEFT OR RIGHT .
- Refer to REMOVING THE LATERAL HOOD SEAL .
- Refer to PARTIALLY DETACHING FRONT AIR SUSPENSION .
- Refer to DETACHING THE UPPER WISHBONE FROM THE SWIVEL BEARING .
- Refer to ATTACHING SWIVEL BEARING IN INSTALLATION POSITION .
- Refer to REMOVING THE SPRING STRUT HOLDER .
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
- Refer to REMOVING THE FRONT THRUST FIELD .
- Refer to REMOVING REAR THRUST FIELD .
- Refer to REMOVING OUTPUT SHAFT .
- Loosen screws (1) .
- Remove bearing bracket (2) .