Install bearing bracket
- Coat the sealing ring (1)
with front axle differential oil.
- Position the bearing bracket (2) at the engine oil pan.
- Tighten the screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Bearing bracket to engine oil pan. | ||
|---|---|---|
| M8 | tightening torque | 19 Nm |
Follow-up work
- Refer to REMOVING RADIAL SHAFT SEAL OF THE BEARING BRACKET .
- Refer to REMOVING THE ASSEMBLY PROTECTION RING OF THE RADIAL SHAFT SEAL RING .
- Refer to INSTALLING RADIAL SHAFT SEAL OF THE BEARING BRACKET .
- Refer to INSTALLING THE INSTALLATION PROTECTION RING OF THE RADIAL SHAFT SEAL .
- Refer to FOR REUSING: CHECKING THE GEARING OF THE OUTPUT SHAFT AND REPLACING THE CIRCLIP .
- Refer to INSTALLING THE OUTPUT SHAFT .
- Refer to CHECK/ADD FRONT AXLE TRANSMISSION OIL .
- Refer to INSTALLING THE REAR THRUST FIELD .
- Refer to INSTALLING FRONT STIFFENING PLATE .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
- Refer to INSTALLING SPRING SUSPENSION STRUT .
- Refer to SECURING THE TOP WISHBONE ON THE SWIVEL BEARING .
- Refer to SECURING THE FRONT AIR SUSPENSION .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT THE REAR LEFT OR RIGHT .
- Refer to FASTENING THE OUTPUT SHAFT ON THE WHEEL BEARING .
- Refer to GREASE THE WHEEL HUB .
- Refer to INSTALLING FRONT LEFT OR RIGHT WHEEL .