Securing the front left and right brake caliper
NOTE:
Perform the steps on the right and left side.
Fastening front brake caliper
- Loosen the special tool 2 413 317 from the brake caliper (1) .
- Position the brake caliper (1) in arrow direction.
- Replace screws (2)
.
Parts: Screws
- Tighten down screws (2) .
TIGHTENING TORQUES SPECIFICATION
| Brake caliper/brake anchor plate at front swivel bearing | ||
| M12 Replace screw. |
tightening torque | 130 Nm |
NOTE:
Only perform the operation on the left side.
- Attach the cable (3) for the brake pad wear sensor to the holders (4) .
- Fasten brake hose (1) to the brackets (2) .