Install the engine bridge
Preliminary work
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to BRINGING FRONT COMPARTMENT LID IN THE SERVICE POSITION .
- Refer to REMOVING THE COVER FOR THE CENTER ENGINE COMPARTMENT .
- Refer to REMOVING THE COVER OF THE REAR RIGHT ENGINE COMPARTMENT .
- Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
- Refer to REMOVING THE FRONT LEFT AND RIGHT WHEELS .
- Refer to REMOVING THE UNDERBODY PROTECTION OF THE STEERING GEAR AND THRUST FIELD RESPECTIVELY .
- Refer to REMOVING REAR UNDERBODY PROTECTION .
- Refer to REMOVING THE REAR SECTION OF THE WHEEL ARCH COVER ON THE FRONT LEFT AND RIGHT .
- Refer to REMOVING THE COVER OF THE STEERING ASSEMBLY .
Prepared engine bridge
CAUTION:
Components connected to the engine joint or cross member.
Injury hazard!
Injury hazard!
- Check lifting eyes and engine mounting brackets for damage, e.g. cracks.
- Attach the component to correctly mounted engine joints or cross members only.
- Only lift the component, do not shift it forwards, backwards or in transverse direction.
Remove the right and left side hood seals
- Loosen the expanding rivet (1) .
- Remove the hood seal (2)
upwards.
- Loosen the expanding rivet (1) .
- Unclip cable (2) in marked areas.
- Remove the hood seal (3) upwards.
- Loosen left and right screw (1)
.
- Carefully position engine bridge (1)
with help from an assistant.
- Make sure that the special tool 0 496 438 (00 6 053) from the set of special tools 0 496 430 (00 6 050) rests correctly on the lock support on the left.
- Make sure that the special tool 0 496 437 (00 6 052)
from the set of special tools 0 496 430 (00 6 050)
rests correctly on the spring bolt on the left.
- Make sure that the special tool 0 496 438 (00 6 053) from the set of special tools 0 496 430 (00 6 050) rests correctly on the lock support on the right.
- Make sure that special tool 0 496 437 (00 6 052)
from the set of special tools 0 496 430 (00 6 050)
rests correctly on the spring bolt on the right.
- Align the engine bridge between the mounting brackets (2) and (3) screw it down.
- Align the lifting gear (1) 0 490 567 (11 0 020)
above the mounting brackets (2)
and (3)
.
- Attach the hooks of the chains (1) in the mounting brackets (2) and (3) .