Installing the lane change warning sensor at the front
NOTE:
TECHNICAL INFORMATION
Detents, guides and mounting elements must not be damaged or missing.
Detents, guides and mounting elements must not be damaged or missing.
NOTE:
Description is for left component only. Procedure on the right side is identical.
NOTE:
To provide a better overview: Schematic diagram with partially hidden components.
- Push the lane change warning sensor (2) into the bracket (3) in arrow direction up to the stop.
- Lock the lock (1).
- Ensure that the lock (1) is locked correctly.
- Connect the connector (1) to the sensor (2) and lock it.
- Correctly position the wheel arch trim panel (1).
- Tighten all bolts (arrows).
TIGHTENING TORQUE SPECIFICATIONS
| Wheel arch cover | ||
| screw | Tightening torque | 3 Nm |
| Plastic nut | Tightening torque | 2.6 Nm |
Follow-up work
- Refer to INSTALLING CENTER TRIM STRIP .
- Refer to INSTALLING TRIM STRIP ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE TRIM ON THE BUMPER COVER ON THE SIDE TO THE LEFT AND RIGHT .
- Refer to INSTALLING THE ORNAMENTAL GRILLE OF THE BUMPER PANEL ON THE LEFT AND RIGHT SIDE .
- Refer to INSTALLING THE FOG LIGHT BRACKET ON THE LEFT AND RIGHT .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to INSTALLING FRONT SECTION OF THE FRONT WHEEL ARCH COVER (PARTIALLY REMOVED) .
- Refer to INSTALLING FRONT ORNAMENTAL GRILLE .
- Refer to INSTALLING THE NUMBER PLATE BASE FOR THE LICENSE PLATE .