Installing fog light support

• Attach fog light support (5).
• Install control unit (4).
• Tighten down screw (3).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Guide to the side on fog light holder
  	Tightening torque	3 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Attach the hose of the headlight cleaning system (2).
• Attach wiring harness (1).
• Engage fog light support (1) to the latch mechanism (arrows).
• Mount the expanding rivets (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installing the high-pressure nozzle of the headlight cleaning system 

• Check the retaining lugs (1) on the high-pressure nozzle (2).

  Retaining lugs must not be damaged or missing.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect high pressure line (1).
• Install high-pressure nozzle (3) to the front.
• Check high-pressure nozzle (3) for correct detent (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Carefully bend up guide (1) of the cover (2) in arrow direction and clip into the high-pressure nozzle (3).
• Allow the high-pressure nozzle (3) of headlamp washer system to slide back slowly.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING BUMPER COVER, FRONT  .
• Refer to INSTALLING FRONT ORNAMENTAL GRILLE .
• Refer to INSTALLING THE NUMBER PLATE BASE FOR THE LICENSE PLATE  .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT CENTER .
• Refer to INSTALLING FRONT SECTION OF THE FRONT WHEEL ARCH COVER (PARTIALLY REMOVED) .