Installing the acoustic cover for the oil sump
Installing the acoustic cover for the oil sump
- Install acoustic cover (1) to the top front.
- Mount all expanding rivets (1) and the fir tree clip.
- Feed terminal 50 (4) in and tighten it with the nut (5).TIGHTENING TORQUES SPECIFICATION
Terminal 50 to starter motor M6 Tightening torque 7 Nm - Insert the positive battery cable (1) and attach it correctly to the anti-twist lock (2).
- Tighten nut (3).TIGHTENING TORQUES SPECIFICATION
Battery positive lead to starter M8 Tightening torque 13.5 Nm - Attach terminal 50 (4) on the clip (6).
Follow-up Work
- Refer to INSTALL FRONT AXLE COMPLETELY .
- Refer to TIGHTEN THE SCREWS ON THE LEFT AND RIGHT FRONT AXLE SUPPORT .
- Refer to SECURE THE SPRING STRUT TO THE BOTTOM WISHBONE .
- Refer to SECURE THE TOP WISHBONE ON THE SWIVEL BEARING .
- Refer to REMOVING THE MOBILE LIFTING TABLE .
- Refer to ATTACHING COOLANT HOSES TO FRONT AXLE SUPPORT .
- Refer to IF INSTALLED: CONNECT THE CONNECTOR OF THE ACTIVE STABILIZER
- Refer to FASTEN THE BRAKE HOSE AT THE FRONT LEFT AND RIGHT .
- Refer to SECURING THE ANTI-ROLL BAR LINK ON THE LEFT AND RIGHT TO THE ANTI-ROLL BAR .
- Refer to IF INSTALLED: INSTALL PARKING HEATER MUFFLER (ADDITIONAL WORK AW NO.: 31 11 905) .
- Refer to SECURE THE WIRING HARNESS FOR THE EPS ON THE FRONT AXLE SUPPORT .
- Refer to IF INSTALLED: CONNECT THE VACUUM HOSE OF THE ENGINE MOUNT ON THE FRONT AXLE SUPPORT .
- Refer to LOWERING THE ENGINE AND REMOVE THE ENGINE BRIDGE .
- Refer to INSTALL THE ENGINE SUPPORT ARMS ON THE ENGINE MOUNTS ON THE LEFT AND RIGHT .
- Refer to SECURING THE UNIVERSAL JOINT ON THE STEERING GEAR .
- Refer to INSTALL THE BRACING STRUT ON THE ENGINE MOUNT ON THE LEFT AND RIGHT
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
- Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT STIFFENING PLATE .
- Refer to INSTALL THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD w.
- Refer to INSTALL THE COVER OF THE STEERING ASSEMBLY ON THE LEFT AND RIGHT .
- Refer to INSTALL THE REAR SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT
- Refer to INSTALL THE WHEEL ARCH COVER ON THE FRONT LEFT AND BOTTOM RIGHT
- Refer to INSTALLING LEFT AND RIGHT BRAKE AIR DUCT .
- Refer to MOUNT THE FRONT LEFT AND RIGHT WHEELS .
- Refer to INSTALL THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALL THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to INSTALLING THE COVER ON THE LEFT AND RIGHT IN THE TOP ENGINE COMPARTMENT
- Refer to INSTALL ACOUSTIC COVER .
- Refer to TAKE BONNET OUT OF THE SERVICE POSITION .
- Refer to CONNECTING ALL BATTERY EARTH LEADS .
- Refer to RESETTING THE TIRE PRESSURE MONITOR .