Removing and installing or replacing trim for rear lid (330i xDrive Wagon, 328d xDrive Wagon)

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 325

When working on trim panel components, make sure that the sensitive surfaces are not scratched or damaged.

Unclip cover (1) towards top.

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) from tailgate trim.

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip cover (1) from the lock strap (2) and set aside.

Courtesy of BMW OF NORTH AMERICA, INC.

Version with light package:

Unclip the left and right luggage compartment light (1) with suitable screwdriver (2).

Release screw (3) under luggage compartment light (1).

Version without light package:

Remove the cover instead of the luggage compartment light.

Release the screw (3) under the covers.

Remove the center tailgate luggage COMPARTMENT LIGHT .

Courtesy of BMW OF NORTH AMERICA, INC.

Open cover (1) on tailgate trim and unclip warning triangle (2).

Release screw (3) under warning triangle.

Courtesy of BMW OF NORTH AMERICA, INC.

Partially unclip tailgate side upholstery (1) on left and right.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Shown removed here for purposes of clarity.
Unclip tailgate trim (1) special tool 00 9 325 (2).

Disconnect the tailgate trim (1) slightly and remove the plug connections from the tailgate push button (3).

Feed out tailgate trim (1) from lock strap and set aside.

Installation note:

Replace faulty or missing clips (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Modify clips (1)
Modify tailgate push button (2)
Modify insulating mat

Attention !

The rear lid button can be difficult to disassemble/mount.

Courtesy of BMW OF NORTH AMERICA, INC.

For replacement (version without light package):

The new trim for the rear lid is only delivered as a light package version.

If necessary, the LEDs for the handle recess and adapter cable must be retrofitted.

Remove the insulating mat
Install the adapter cable (2) and secure it with adhesive tape (3) to the trim panel
When installing the trim panel, install new LEDs (1) instead of the cover

Courtesy of BMW OF NORTH AMERICA, INC.