Removing and installing/replacing cover on window frame of rear door (front), left or right (330i xDrive Wagon, 328d xDrive Wagon)
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Open rear side window
- Detach door window frame COVER in B-pillar area.
- Remove inner WEATHER STRIP .
- Remove outer WEATHER STRIP .
IMPORTANT:
The "INSTRUCTIONS
on fitting window guide seals" serve as the basis for this repair instruction and must be observed without fail.
Detach rubber seal (1) and rubber window seal (2) from cover.
Installation note:
Coat rubber seal (1) and rubber window seal (2) with APPROVED LUBRICANT before mounting.
Make sure rubber seal (1) and rubber window seal (2) are correctly seated on cover.
Release screws (1).
Carefully detach trim (2) towards front/top.
Installation note:
Fitted foam parts must not be damaged when cover (2) is pushed in.