Removing and installing/replacing trim cover on front door window frame, left or right (330i xDrive Wagon, 328d xDrive Wagon)
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Open side window
- Remove WEATHER STRIP .
- Remove door window frame COVER .
Pull rubber window seal (1) out of rear window guide.
Unfasten screws (2).
Push cover (3) down slightly and unfeed rubber window seal (1) toward the top.
Then feed cover (3) upward out of the door.
Installation note:
If necessary, replace faulty plastic nuts for screws (2).
Wet rubber window seal (1) prior to fitting with APPROVED LUBRICANT .
Make sure rubber window seal (1) is correctly seated on cover (3).
Installation note:
Sealing (1) on cover (2) must not be damaged or missing.