Removing and installing/replacing center console cover (330i xDrive Wagon, 328d xDrive Wagon, 330i GT xDrive, 340i GT xDrive)
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 00 9 325
When working on trim panel components, make sure that the sensitive surfaces are not scratched or damaged.
Necessary preliminary tasks:
- Remove center console DECORATIVE TRIM
- Remove CENTER CONSOLE OPERATING UNIT .
Release screws (1).
Release cover (2) with special tool 00 9 325 from clamps (3).
Slightly raise the cover (2) and disconnect associated plug connection.
Feed out cover (2) to the top/rear.
Installation note:
Ensure correct cable routing.
Installation note:
When installing make sure springs (1) are not disengaged.
Replace faulty clamps.
Replacement:
- Modify 12 V CHARGING SOCKET (2)
- Modify interior AERIAL (3)