Remove heat shield on the cylinder head cover on left at cylinders 5 to 8
Preliminary work
- Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
- Refer to REMOVING INTAKE SILENCER HOUSING .
- Refer to REMOVING LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to REMOVING TRAILING LINK AT SPRING BOLT .
- Refer to REMOVING THE CENTER BULKHEAD LOWER PART .
- Refer to REMOVING THE LAMBDA OXYGEN SENSOR AND THE MONITORING OXYGEN SENSOR FOR CYLINDERS 1 TO 4 .
- Refer to REMOVING THE LAMBDA OXYGEN SENSOR AND THE MONITORING OXYGEN SENSOR FOR CYLINDERS 5 TO 8 .
- Refer to REMOVING ENGINE VENTILATION LINE .
- Refer to REMOVING UPPER HEAT SHIELD .
- Refer to BENDING THE HEAT SHIELD TO THE REAR .
- Refer to RELEASING SCREW BETWEEN THE LEFT AND RIGHT HEAT SHIELD .
- Refer to REMOVING RIGHT HEAT SHIELD .
- Refer to BENDING THE HEAT SHIELD TO THE REAR .
- Refer to REMOVING LEFT CLEAN AIR PIPE .
- Refer to REMOVING LEFT CHARGE AIR COOLER .
- Refer to REMOVING THE DME CONTROL UNIT FOR CYLINDERS 1 TO 4 .
- Refer to REMOVING THE INTEGRATED POWER SUPPLY MODULE (PDM) .
- Refer to PARTIALLY LOOSENING THE WIRING HARNESS FROM THE CYLINDER HEAD COVER ON THE LEFT .
- Refer to REMOVING IGNITION COILS .
- Refer to REMOVING THE SOUND INSULATION FROM CYLINDER HEAD COVER ON LEFT .
- Refer to REMOVING THE HIGH-PRESSURE RAIL ON THE LEFT .
- Refer to REMOVING INJECTORS .
- Refer to REMOVING FUEL DELIVERY LINE .
- Refer to REMOVING THE HEAT SHIELD OF THE HIGH-PRESSURE PUMP CYLINDER HEAD COVER ON THE LEFT, CYLINDERS 5 TO 8 .
- Refer to REMOVING LEFT HIGH PRESSURE PUMP .
- Loosen screws (1).
- Remove the heat shield (2).