Removing and installing the front seat on the passenger's side (normal/manual) (330i xDrive Wagon, 328d xDrive Wagon, 330i GT xDrive, 340i GT xDrive)

Necessary preliminary work: 

• Disconnect BATTERY NEGATIVE CABLE .

Installation note: 

• Powerlok screws must be replaced and must not  be reused
• Powerlok screws are mechanical screw lockings with trilobular threads

Move backrest to full rearward position.

Grip end fitting cover in marked area between cushion and cover.

Unclip end fitting cover in direction of arrow (1).

Feed out end fitting cover (2) in direction of arrow.

Courtesy of BMW OF NORTH AMERICA, INC.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Install end fitting cover as follows: 

1. Insert cover with front guide in cover
2. Insert cover in direction of arrow downwards in covering
3. Engage top cover in marked area in covering.

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque 72 11 2AZ .

Remove seat belt end fitting.

Installation note: 

End fitting is coded against incorrect assembly.

Move seat to upper back position.

Release and dispose of screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Courtesy of BMW OF NORTH AMERICA, INC.

Adjust the seat to the front top.

Release and dispose of screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Lift out front seat.

Installation note: 

• Carpet must not get between seat rails and floor panel in area of attachment points (creaking noises)
• Replace microencapsulated screws
• Insert all screws loose to avoid twisting
• Tighten down all screws to specified torque specifications

Tightening torque 52 10 1AZ .