Removing and installing/replacing left or right rear window frame cover (330i GT xDrive, 340i GT xDrive)
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 00 9 325
Necessary preliminary tasks:
- Remove top rear window frame COVER .
NOTE:
The operation is described on the left side; proceed in the same way for the right side.
When working on trim panel components, make sure that the sensitive surfaces are not scratched or damaged.
Release the cover (1) at the clips using special tool 00 9 325 and remove.
Installation note:
The clamps (1) and latch mechanisms (2) of the cover (3) must not be damaged or missing.
If necessary, replace retainers (1).
Replacement
Remount clamps (1).
Release the cover (1) at the clips and remove.
Installation note:
The clips (1) and latch mechanisms (2) on the cover (3) must not be damaged or missing.
If necessary, replace clips (1).
Replacement
Remount clips (1).