Removing and installing/replacing Start/Stop switch (330i xDrive Wagon, 328d xDrive Wagon, 330i GT xDrive, 340i GT xDrive)
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 00 9 325
NOTE:
When working on trim panel components, make sure that the sensitive surfaces are not scratched or damaged.
Pry out Start/Stop switch (1) at the marked retaining points using special tool 00 9 325.
Disconnect associated plug connection and remove Start/Stop switch (1).
Installation note:
Retaining clips (1) on Start/Stop switch (2) must not be bent or damaged.