Removing and installing operating element for assist system (330i xDrive Wagon, 328d xDrive Wagon, 330i GT xDrive, 340i GT xDrive)
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 00 9 327
When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .
NOTE:
Work shown on the F30 by way of example, deviations in detail are possible in other models.
Carefully release cover (1) from clamps (2) with special tool 00 9 327.
Disconnect associated plug connection and remove cover (1).
Installation note:
Make sure cover (1) is correctly seated.
Remove operating element (1) by releasing retaining clips (2) from cover (3).
Installation note:
Make sure operating element (1) is correctly seated in cover (2).
Installation note:
Guides (1) and clamps (2) on cover (3) must not be damaged or missing.