Replacing the front BMW badge (330i xDrive Wagon, 328d xDrive Wagon, 330i GT xDrive, 340i GT xDrive)
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 00 9 327
IMPORTANT:
The NOTES on component bonding with double-sided adhesive tape serve as the basis for this repair instruction and must be observed without fail.
Tape off working area around the BMW badge (1) with adhesive tape.
Carefully warm up the BMW badge (1) with a hot air blower (temperature approx. 40 55°C) and lift it out with the special tool 00 9 327.
Installation note:
Pull liner* off adhesive tape (2).
Position BMW badge (1) over guides (3) and press down firmly.
* Liner is the protective film on a new plate.