51 13... Removing and installing/replacing partition wall attachment, right (330i xDrive Wagon, 328d xDrive Wagon, 330i GT xDrive, 340i GT xDrive)

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Turn locks (1) 90° counterclockwise.

Unlock catch (3).

Remove cover (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Release clip (1).

Turn snap fastener (2) approx. 90° counterclockwise.

Disconnect plug connection (3) and feed out cable.

Release screws (6) and feed out attachment (5).

Replacement:

Twist sensor (4) approx. 90° counterclockwise and remove.

Installation note:

The following versions may be fitted:

Attachment (1) without air filter
Attachment (1) with air filter (2)

Courtesy of BMW OF NORTH AMERICA, INC.
Attachment (1) with air filters (2 and 3)
Attachment (1) must only be fitted with air filter (2).

If necessary, remove air filter (3) and/or attach air filter (2) at position illustrated.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Grille (1) on sealing frame (2) must be fitted.

If necessary attach new grille (1).

Grille (1) is pressed onto sealing frame (2) by air filter on attachment.

Grille (1) in conjunction with the air filter on the attachment prevents foreign objects entering.

Courtesy of BMW OF NORTH AMERICA, INC.