Replacing base plate for number/license plate (330i GT xDrive, 340i GT xDrive)

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

2 285 029
2 355 633
2 246 254
2 354 940

Only use the vehicle-specific number plate baseplate.

The installation of other license plate baseplates is not permissible.

The number plate must be precisely mounted on the number plate baseplate.

If a number plate baseplate is not offered for the corresponding national-market version, the number plate must be screwed directly onto the bumper using a drilling template.

Incorrect assembly leads to a malfunction of the sensors of the driver assist systems.

Schematic diagram is example of F32 Europe national-market version.

Release screws (1).

Tightening torque 51 11 8AZ .

Remove holder (2) towards front.

Courtesy of BMW OF NORTH AMERICA, INC.

Courtesy of BMW OF NORTH AMERICA, INC.

If replacing bumper:

Place template against bumper and align.

Mark the holes for the number plate baseplate on the bumper.

Drill out marks on bumper to 10 mm.

NOTE: Use the template only for the purpose of marking the hole positions.
Use only the drilling template prescribed for the specific model series:

F32/F33/F36 Series	2 285 029
F32/F33/F36 M Aerodynamic package	2 355 633
F34 Series	2 246 254
F34 M Aerodynamic package	2 354 940

Attach support (2) to bumper and insert screws (1).

Tightening torque 51 11 8AZ .

Courtesy of BMW OF NORTH AMERICA, INC.