Instructions for ACC adjusting device (330i xDrive Wagon, 328d xDrive Wagon, 330i GT xDrive, 340i GT xDrive)

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: This service information is valid for the entire F-series with the new ACC sensor.

Courtesy of BMW OF NORTH AMERICA, INC.

Requirements for the measurement area for ACC adjusting device Dimensions:

Area behind the mirror of at least 80 cm that cane be entered
Distance between mirror and vehicle 80 cm +/- 5 cm (Distance between mirror and ACC sensor 100 cm +/- 5 cm)
Total area of work area 360 cm x 660 cm

Maximum irregularity of floor surface:

Floor surface - adjusting device ≤ 1 mm
Floor surface - vehicle ≤ 10 mm

Courtesy of BMW OF NORTH AMERICA, INC.

Maximum angle of inclination of floor surface - vehicle:

Downward incline of floor surface maximum 3°, see graphic above (1)
Upward incline of floor surface maximum 1°, see graphic above (2)

NOTE: Setting up the ACC adjusting device (one-off task) comprises the following steps:

Assembly of adjusting device
Assembly of rail
Basic setting of adjusting device on measurement area

Detailed setup and operating instructions are enclosed with every ACC adjusting device .