Removing and installing/replacing a front right (outside) ultrasonic transducer (Park Distance Control) (330i xDrive Wagon, 328d xDrive Wagon, 330i GT xDrive, 340i GT xDrive)
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove front BUMPER PANEL .
Disconnect plug connection.
Unlock retaining tabs (1) in direction of arrow and pull ultrasound transducer (2) upward out of bracket (3).
Installation note:
Before installation of ultrasonic sensor (2) on wiring harness, clean plug connection!
Retaining hooks (1) of ultrasonic transducer (2) must engage exactly in mountings (3).
Installation note:
Make sure rubber ring (1) is correctly seated on ultrasonic sensor (2).