Install the oil vacuum pump

• Feed oil vacuum pump (1) in the drive chain (2) and position.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace screws (1).

  Parts:  Screws

• Tighten the screws (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUES SPECIFICATION
  
  

  Oil vacuum pump to crankcase
  M8 Replace screw.	1. Joining torque	15 Nm
  	2. Angle of rotation	45°

Follow-up work 

• Refer to REFITTING ENGINE OIL PAN .
• Refer to INSTALLING THE HOLDER FOR THE THERMOSTAT ON THE TRANSMISSION OIL LINES .
• Refer to INSTALLING THE THERMOSTAT ON THE TRANSMISSION OIL LINES .
• Refer to INSTALLING STARTER MOTOR .
• Refer to INSTALLING THE ACOUSTIC COVER FOR THE OIL SUMP .
• Refer to TOPPING UP THE MOTOR OIL .
• Refer to CONNECTING NEGATIVE BATTERY CABLE .
• Refer to CHECKING/TOPPING UP THE OIL LEVEL IN THE AUTOMATIC TRANSMISSION .
• Refer to CHECKING ENGINE OIL LEVEL .
• Refer to INSTALLING THE REAR THRUST FIELD .
• Refer to INSTALLING REAR UNDERBODY PROTECTION .