Installing the trim panel for the pedal assembly

• Connect associated connector.

  Hook the trim panel for pedal assembly (1) in the guides (4) and fold it upwards.

• Clip in the trim panel for pedal assembly (1) in the area (2) in the center console.
  NOTE: TECHNICAL INFORMATION  The screw caps of the trim panel must be  correctly locked in place. This is the only way to ensure that the trim panel does not loosen and, as a result, tilt into the pedal area.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert screw caps (3) correctly and turn 90° to lock.

Follow-up work 

• Install the pedal assembly TRIM PANEL .
• Install the UNIVERSAL JOINT .
• Install the HEAT SHIELD
• Install the CATALYTIC CONVERTER for cylinders 5 to 8.
• Align the VACUUM PUMP for the camshaft.
• Replace the vacuum pump O-RING .
• Install the VACUUM PUMP .
• Bend the front HEAT SHIELD .
• Install right HEAT SHIELD .
• Install left HEAT SHIELD .
• Tighten left and right heat shield SCREW .
• Install top HEAT SHIELD
• Install engine VENTILATION LINE
• Install the LAMBDA OXYGEN SENSOR and the monitoring oxygen sensor for cylinders 1 to 4.
• Install the LAMBDA OXYGEN SENSOR and the monitoring oxygen sensor for cylinders 5 to 8.
• Install the upper part center COWL .
• Install shock tower TENSION STRUT .
• Install windshield panel COVER .
• Install left and right WIPER ARM .
• Install the rear right engine compartment COVER .
• Install the rear left engine compartment COVER .
• Install EXHAUST SYSTEM .
• Install the connecting supports TUNNEL .
• Install intake filter HOUSING .
• Install acoustic COVER .
• Install the left steering assembly COVER .
• Install the THRUST FIELD .
• Attach the front left WHEEL .
• Check the steering wheel STRAIGHT-AHEAD DRIVING POSITION .
• CHECK the airbag for function.