Install front stiffening plate
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Replace screws (2).
Parts: Screws
- Position stiffening plate (1).
- Tighten down screws (2).TIGHTENING TORQUES SPECIFICATION
Thrust field to front axle support M8 Replace screws. Joining torque 25 Nm Angle of rotation 70° - Tighten down screws (3).TIGHTENING TORQUES SPECIFICATION
Thrust field to holder M6 Tightening torque 8 Nm - Tighten down screws (4).TIGHTENING TORQUES SPECIFICATION
Underbody protection screw Tightening torque 3 Nm