Remove the transfer box (ATC 13-1)
Preliminary work
- Refer to DEACTIVATING THE 48 V ELECTRICAL SYSTEM .
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING REAR UNDERBODY PROTECTION .
- Refer to REMOVING THE CENTER UNDERBODY PROTECTION .
- Refer to REMOVING THE CONNECTING SUPPORT FROM THE TUNNEL .
- Refer to REMOVING COMPLETE EXHAUST SYSTEM .
- Refer to REMOVING THE HEAT SHIELDS .
- Refer to PARTIALLY LOOSENING THE PROP SHAFT .
- Refer to REMOVING TRANSMISSION CROSS-MEMBER .
- Unscrew the bolt (1)
and disconnect the ground strap (2)
.
- Disconnect connector (1) from transfer box control unit (longitudinal torque distribution) (2)
.
- Unscrew the screw connection (arrows) of the transfer box.
- Tie the front prop shaft to the underbody.
It is imperative to prevent damage to the surface coating!
- Carefully pull the transfer box off.