Install the DSC control unit

• Carefully mount the DSC control unit (1)  on the hydraulic unit.
• Replace the screws (2)  .

  Parts:  Screws

• Tighten screws (2)  crosswise gradually.

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUE SPECIFICATION
  
  

  DSC control unit on hydraulic unit
  Screw Replace screws. Screw in screws and evenly tighten crosswise.	1. tightening torque	1.5 Nm
  	2. tightening torque	2.5 Nm
  	Position the 3rd tightening torque	3.5 Nm

• Install holder (2)  .
• Replace screws (1)  .

  Parts:  Screws

• Insert screws (1)  and tighten.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE HYDRAULIC UNIT .
• Refer to INSTALLING COOLANT EXPANSION TANK .
• Refer to REMOVING THE BRAKE PEDAL TENSIONER .
• Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to FLUSH AND VENTING THE REAR AXLE BRAKE CIRCUIT .
• Refer to FLUSHING AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT .
• Refer to FLUSH AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT (BRAKE HIGH) .
• Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
• Refer to DSC UNIT START-UP/DRIVING DYNAMICS SENSOR ADJUSTMENT/CONTROL UNIT PROGRAMMING .