Removing the control unit for limited slip differential
NOTE:
TECHNICAL INFORMATION
If the individual data recovery for the GHAS control unit failed, the data must be read from the sticker on the rear differential and entered using the keyboard. Reading the data using an endoscope (see special tool).
If the individual data recovery for the GHAS control unit failed, the data must be read from the sticker on the rear differential and entered using the keyboard. Reading the data using an endoscope (see special tool).
Preliminary work
- Refer to DEACTIVATING THE 48 V ELECTRICAL SYSTEM .
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING REAR WINDOW STORAGE SHELF AT FRONT .
- Refer to REMOVING LUGGAGE COMPARTMENT FLOOR COVERING .
- Refer to REMOVING THE LOADING EDGE TRIM .
- Refer to REMOVING THE RIGHT LUGGAGE COMPARTMENT COVER .
- Refer to REMOVING LED IN LUGGAGE COMPARTMENT ON RIGHT .
- Refer to REMOVING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL .
- Release nuts (1).
- Remove shelf (2).
- Unlock and disconnect plug connections (1).
- Release nuts (2).
- Remove control unit (3).