Removing the camber control arm
WARNING:
Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly
.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Observe safety instructions on raising the vehicle using a vehicle hoist.
- For additional information see: 00... RAISING THE VEHICLE WITH A VEHICLE LIFT .
NOTE:
TECHNICAL INFORMATION
PERFORM CHASSIS ALIGNMENT CHECK after installation.
PERFORM CHASSIS ALIGNMENT CHECK after installation.
Preliminary work
- Refer to REMOVING REAR LEFT OR RIGHT WHEEL .
- Refer to REMOVING THE COVER OF THE CAMBER CONTROL ARM .
- Refer to LOOSENING THE REAR SHOCK ABSORBER FROM THE CAMBER CONTROL ARM .
- Refer to REMOVING COIL SPRING .
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Unclip the holder (2) for the ride height sensor from the camber control arm (1).
- Release and remove stone chip guard (1).
- Loosen nut (1).
- Pull out screw (2).
NOTE:
TECHNICAL INFORMATION
Secure component against falling.
Secure component against falling.
- Mark the position of the eccentric washer (3) for the rear axle support to simplify subsequent setting of the rear axle.
- Release nut (1) and remove the eccentric washer.
- Pull out the eccentric screw (2).
- Remove the camber arm (4).