Measuring the installation position (protrusion)
WARNING:
Car may slip off the vehicle hoist where components are supported
.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Secure the vehicle hoist against lowering and lifting.
- Make sure that the vehicle does not lift off the mounting plates on the vehicle lift.
WARNING:
Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly
.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Observe safety instructions on raising the vehicle using a vehicle hoist.
- For additional information see: 00... RAISING THE VEHICLE WITH A VEHICLE LIFT .
Preliminary work
- Refer to REMOVING THE COVER OF THE CAMBER CONTROL ARM ON THE LEFT AND RIGHT .
- Refer to REMOVING THE CONNECTING SUPPORT FROM THE TUNNEL .
- Refer to REMOVING COMPLETE EXHAUST SYSTEM .
- Refer to REMOVING HEAT SHIELD AT REAR .
- Refer to RELEASING CENTRAL MOUNT OF THE PROP SHAFT .
- Refer to RELEASING THE WIRING HARNESS FROM THE M SPORT DIFFERENTIAL .
- Refer to LOWERING REAR DIFFERENTIAL .
- Before the removal, it is necessary to measure the protrusion (A) of the rubber mount or hydro mount (1) at the rear axle support (2).
(F) = driving direction