Install the trailing link
- Replace the cage nut (1).
Parts: Cage nut
- Push output shaft (1) slightly upwards.
- Feed in the tension strut (2) in the arrow direction.
- Position the tension strut at the swivel bearing (2).
- Replace nut (1).
Parts: Nut
- Tighten nut (1).
NOTE:
Counter-hold at the Torx socket.
TIGHTENING TORQUE SPECIFICATION
| Tension strut to swivel bearing | ||
|---|---|---|
| M14 Replace nut. |
tightening torque | 175 Nm |
NOTE:
TECHNICAL INFORMATION
Tighten the screw connection in the NORMAL POSITION .
Tighten the screw connection in the NORMAL POSITION .
- Position the tension strut and crash lever (2) on the front subframe.
- Replace the screw (1).
Parts: Screw
- Feed in screw (1) and tighten hand-tight.
NOTE:
The screw connection is tightened later in NORMAL POSITION
.
Follow-up work
- Refer to FASTENING THE OUTPUT SHAFT ON THE WHEEL BEARING .
- Refer to INSTALLING FRONT LEFT OR RIGHT WHEEL .
- Refer to MEASURING THE RIDE HEIGHT OF THE FRONT AXLE AND ADJUSTING THE NORMAL POSITION .
- Refer to TIGHTENING THE SCREW CONNECTION OF THE TENSION STRUT ON THE FRONT SUBFRAME .
- Refer to INSTALLING THE LOWER WHEEL ARCH COVER .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .