Installing the upper seat belt

WARNING: Pyrotechnic components.
Danger! Immobilization period-threatening injuries!

All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
Replace any damaged part or ones that have been dropped.
For additional information see: 72 00 SAFETY REGULATIONS ON HANDLING COMPONENTS WITH GAS GENERATORS .

WARNING: Airbag unit.
Danger! Immobilization period-threatening injuries!

Before performing any work on the airbag, always disconnect the battery ground lead from the battery.
Airbag unit may only be set down with the cushion (airbag itself) facing upwards.
For additional information see: 72 00 SAFETY REGULATIONS ON HANDLING COMPONENTS WITH GAS GENERATORS

NOTE: TECHNICAL INFORMATION
Clean all threaded belt connections with micro-encapsulated outer and internal threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength .
The screw connection must be completed within 10 minutes as hardening begins after this period.

Position the seat belt retractor (3).
Replace the screw (2).
Parts: Screw

Tighten down screw (2).

TIGHTENING TORQUE SPECIFICATION

Front seat belt retractor to body
Screw Replace screw.	Tightening torque	42 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connectors (1) and lock.
NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details.
Position the seat belt guide loop (4).

Tighten down screw (3).

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUE SPECIFICATION

Seat belt guide loop on body
Screw	tightening torque	42 Nm

Attach slide bar (2).
Tighten the screws (1).

TIGHTENING TORQUE SPECIFICATION

Slide bar to body B-pillar
Screw	Tightening torque	5 Nm