Removing the roof-mounted antenna housing
NOTE:
RISK OF DAMAGE
Careless handling of tools and sharp-edged components.
Scratches, surface damage.
Careless handling of tools and sharp-edged components.
Scratches, surface damage.
- Protect working area.
- Handle tools and components carefully.
- Slide the yellow plastic adhesive tape (2) as far as possible under roof-mounted antenna housing (3).
CONSUMABLE SPECIFICATION
| Yellow plastic adhesive tape | 83199410979 |
- Mask roof outer skin (1) as shown.
- Position special tool 2 470 382 (1) in conjunction with special tool 0 494 968 (65 2 010)
as shown.
Angle (a) = approx. 45° to the roof outer skin.
Angle (b) = approx. 45° to the roof-mounted antenna housing
- Cut through the adhesive bead all around in the arrow direction and remove roof-mounted antenna housing (2).
NOTE:
If greater effort is required, reposition special tool 1 to recut the adhesive bead if necessary.
- Repair paint damage if necessary.
See ADDITIONAL INFORMATION. .