Install the roof-mounted antenna housing
NOTE:
The preparations correspond to the instructions of bound windscreens; see ADDITIONAL INFORMATION.
.
NOTE:
TECHNICAL INFORMATION
The following procedure forms the basis for these repair instructions and must be observed without fail.
The following procedure forms the basis for these repair instructions and must be observed without fail.
- Check centering pins (1) for damage.
- Clean the bonding surface (2) with cleaning agent R1.
CONSUMABLE SPECIFICATION
| Cleaning agent R1 | 100 ml, Bottle | 83192211217 |
- Apply trace of adhesive bead all round outer contour as follows.
- Distance between adhesive bead and edge of antenna housing:
- (A) = 6.5 mm ±1 mm
- The start and end of the bead must overlap by a maximum of 10 mm.
- To prevent the adhesive from leaking, the adhesive bead diameter must not exceed 2.5 mm to 3.5 mm.
- Join the empty housing coated with adhesive (3) to block by hand.
- To spread the adhesive better, move the empty housing horizontally (3) back and forth while lightly pressing down.
- If necessary, fix the empty housing (3) with adhesive tape and press evenly.
- After bonding, leave vehicle to stand for at least 3 hours at room temperature.
- Remove the adhesive tape (2) from the outer roof panel (1) and if necessary from the empty housing (3).