Securing the brake caliper
- Release and remove special tool 2 413 317
.
The brake caliper must not hang on the brake hose.
- Position the brake caliper (2) in the arrow direction.
- Replace screws (1).
Parts: Screws
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATION
| Brake anchor plate to rear wheel carrier | ||
| M12 Replace screw. |
Tightening torque | 130 Nm |
- Attach the cable for the parking brake (1) to the holders (2).
NOTE:
Only perform the operation on the right side.
- Attach the cable for the brake pad wear indicator to the rear axle support.